AT Shift Lock Solenoid and "P" Range Switch: Removal

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Remove the console box. <Ref. to REMOVAL , Console Box .>
Disconnect the connector.
Remove the indicator bulb.

Fig 1: Removing Indicator Bulb
Courtesy of SUBARU OF AMERICA, INC.
Remove the grip.
Remove the indicator cover.

Fig 2: Locating Indicator Cover Clip
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from the guide plate upper.

Fig 3: Disconnecting Connector From Guide Plate Upper
Courtesy of SUBARU OF AMERICA, INC.
Shift the select lever to the N range, and then remove the detent spring.

Fig 4: Identifying Detent Spring
Courtesy of SUBARU OF AMERICA, INC.
Remove the switch assembly and shift lock solenoid assembly.

Fig 5: Identifying Switch Assembly And Shift Lock Solenoid Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolt to remove the guide plate upper (A) from the plate lower (B).

Fig 6: Locating Guide Plate Upper Bolt
Courtesy of SUBARU OF AMERICA, INC.
Raise the claw of the connector.

Fig 7: Raising Claw Of Connector
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the terminal of the "P" range switch from connector, using a flat-tip screwdriver with a thin tip.

Fig 8: Disconnecting Terminal Of "P" Range Switch From Connector
Courtesy of SUBARU OF AMERICA, INC.