Rear Gate Glass: Installation

Apply the primer to the glass and body sides in the same procedure as for windshield glass. <Ref. to INSTALLATION , Windshield Glass. >
Process the cartridge nozzle tip as shown in the figure, and set the adhesive in sealant gun.

Fig 1: Identifying Cartridge Nozzle Tip Dimension
Courtesy of SUBARU OF AMERICA, INC.
Apply adhesive in the same procedure as for windshield glass. <Ref. to INSTALLATION , Windshield Glass. >

Fig 2: Applying Adhesive In Windshield Glass
Courtesy of SUBARU OF AMERICA, INC.

Fig 3: Adhesive Dimensions For Windshield Glass
Courtesy of SUBARU OF AMERICA, INC.
Insert the glass locating pin into the hole on rear gate panel and push on the area around the locating pin to secure it.
NOTE: Insert the locating pin into the lower hole of the rear gate panel.

Fig 4: Inserting Locating Pin Into Lower Hole Of Rear Gate Panel
Courtesy of SUBARU OF AMERICA, INC.
Push lightly all around the locating pin to seal it.
About one hour after installation, conduct a leak test.
After completion of all work, allow the vehicle to stand for about 24 hours.
NOTE:
- When door is opened/closed after glass is bonded, always lower the door glass first, and then open/close it carefully.
- Move the vehicle slowly.
- For minimum drying time and vehicle standing time before driving after bonding, follow instructions or instruction manual from the adhesive manufacturer.
- When a vehicle is returned to the user, tell him or her that the vehicle should not be subjected to heavy impact for at least three days.
Connect the rear defogger terminals.
Install the rear wiper. <Ref. to INSTALLATION , Rear Wiper Motor . >