Compulsory Valve Operation Check Mode: Operation
- Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description. >
- Prepare the personal computer which has been installed the Subaru Select Monitor.
- Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
- Connect the diagnosis cable to the SDI.
- Connect the delivery (test) mode connector (A) located under the glove box.
- Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
Courtesy of SUBARU OF AMERICA, INC.
CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool. - Start up the personal computer.
- Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
- On the «Main Menu» display screen, select the {Each System Check}.
- On the «System Selection Menu» display screen, select the {Engine Control System}.
- Click the [OK] button after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select the {System Operation Check Mode}.
- On the «System Operation Check Mode» display screen, select the {Actuator ON/OFF Operation}.
- Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen and click the [Next] button.
- Clicking the [End] button completes the compulsory valve operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
- A list of the support data is shown in the following table.
LIST OF SUPPORT DATA
| Description | Display |
|---|---|
| Compulsory fuel pump relay operation check | Fuel Pump |
| Compulsory purge control solenoid valve operation check | CPC Solenoid |
| Compulsory radiator fan relay operation check | Radiator Fan Relay |
| Compulsory air conditioning relay operation check | A/C Compressor Relay |
| Compulsory pressure control solenoid valve operation check | PCV Solenoid Valve |
| Compulsory drain valve operation check | Vent. Control Solenoid Valve |
NOTE:
- The following parts will be displayed but not functional.
DISPLAY REFERENCE CHART
| Display |
|---|
| EGR Solenoid Valve |
| ASV Solenoid Valve |
| FICD Solenoid |
| Pressure Switching Sol. 1 |
| Pressure Switching Sol. 2 |
| AAI Solenoid Valve |
| Tank Sensor Cntl Valve |
| Turbocharger Wastegate Solenoid |
| EXH. Bypass Control Permit Flag |
| Secondary Air Combination Valve 1 |
- For detailed operation procedure, refer to the PC application help for Subaru Select Monitor.