Select Cable: Adjustment

Set the vehicle on a lift.
Set the select lever to "N" range.
Lift up the vehicle.
Remove the rear exhaust pipe and muffler.
- Non-turbo model
  < Ref. to REMOVAL , Rear Exhaust Pipe . > < Ref. to REMOVAL , REMOVAL, Muffler . >
- Turbo model
  < Ref. to REMOVAL , Rear Exhaust Pipe . > < Ref. to REMOVAL , Muffler . >
Loosen the adjusting nuts on both sides.

Fig 1: Identifying Adjusting Nuts
Turn the adjusting nut B until it lightly touches the connector.

Fig 2: Identifying Front Side Of Selector Lever And Connector
Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque:

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 3: Identifying Adjusting Nuts
After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
Install in the reverse order of removal.