MT Gear Shift Lever: Installation

Install the joint to the transmission and secure with spring pin.
Insert the lever COMPL from room side.
NOTE: After inserting the rod and stay, temporarily put them onto transmission mount.

Fig 1: Identifying Lever COMPL
Lift up the vehicle.
Install the joint to the shifter arm.
Insert the spring pin.

Fig 2: Identifying Spring Pin And Joint
Mount the cushion rubber on the body.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 3: Identifying Cushion Rubber And Stay
Connect the rod to the joint.
Tightening torque:

12 N.m (1.2 kgf-m, 8.9 ft-lb)

Fig 4: Identifying Stay And Rod
Connect the stay to the transmission bracket.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 5: Identifying Transmission Bracket And Stay
Install the rear exhaust pipe and muffler.
- Non-turbo model
  < Ref. to INSTALLATION , Rear Exhaust Pipe . > < Ref. to INSTALLATION , Muffler . >
- Turbo model
  < Ref. to INSTALLATION , Rear Exhaust Pipe . > < Ref. to INSTALLATION , Muffler . >
Lower the vehicle.
Install the plate assembly to the vehicle body.
Tightening torque:

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 6: Identifying Plate Assembly Of Vehicle Body
Install the boot and insulator assembly to vehicle in the proper direction.

Fig 7: Identifying Bushing And Insulator Assembly
Install the clamp.
Install the console box. < Ref. to INSTALLATION , Console Box . >