Read Current Data
- On the « Main Menu », select {Each System Check}.
- On the « System Selection Menu », select {Transmission}.
- After transmission type information pops up, select [OK].
- On the « Transmission Diagnosis », select {Current Data Display & Save}.
- On the « Current Data Display & Save », select {Normal sampling}.
- Using the scroll key, scroll the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.SUPPORT DATA
Contents Display Unit of measure Battery voltage Battery Voltage V Rear vehicle speed sensor signal Rear Wheel Speed km/h or MPH Front vehicle speed sensor signal Front Wheel Speed km/h or MPH Engine speed signal Engine Speed rpm ATF temperature ATF Temp. °C or °F Gear position Gear Position - Line pressure control duty ratio Line Pressure Duty Ratio % Lock up clutch duty ratio Lock Up Duty Ratio % Transfer clutch duty ratio Transfer Duty Ratio % Torque converter turbine speed signal Turbine Revolution Speed rpm 2-4 brake duty ratio Brake Clutch Duty Ratio % Low clutch duty ratio L/C Duty % High clutch duty ratio H/C Duty % Low & reverse brake duty ratio L&R/B Duty % Accelerator position Accel. Opening Angle % ATF temperature light ATF Temperature Lamp ON or OFF Stop light switch signal Stop Light Switch Signal ON or OFF Parking range signal P Range Signal ON or OFF Neutral range signal N Range Signal ON or OFF Reverse range signal R Range Signal ON or OFF Drive range signal D Range Signal ON or OFF 3rd range signal 3rd Range Signal ON or OFF 2nd range signal 2nd Range Signal ON or OFF 1st range signal 1st Range Signal ON or OFF AT diagnosis light output signal Diagnosis Lamp ON or OFF FWD switch signal FWD SW ON or OFF Shift lock solenoid signal Shift Lock Solenoid ON or OFF Cruise control signal Cruise Control Signal ON or OFF
NOTE:
For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".