LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester XT, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4AT (Diagnostics) >> Subaru Select Monitor >> Operation >> Clear Memory Mode

Clear Memory Mode

  1. Check that the select lever is in "P" range.
  2. On the « Main Menu », select {Each System Check}.
  3. On the « System Selection Menu », select {Transmission}.
  4. After transmission type information pops up, select [OK].
  5. On the « Transmission Diagnosis », select {Clear Memory}.
  6. When "Done. Turn ignition switch to OFF" pops up, select [OK].
  7. Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
NOTE:
  • If {Clear Memory 2} is selected and performed, DTC and learned control memory are cleared. If {Clear Memory 2} is performed, execute the advance operation of learning control. < Ref. to FACILITATION OF LEARNING CONTROL , OPERATION, Subaru Select Monitor.>
  • For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".
scientia non olet · About LEMON Manuals