LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester XT, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (4AT) >> Front Differential Assembly >> Removal

Front Differential Assembly: Removal

  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly.>
  2. Pull out the torque converter clutch assembly. < Ref. to REMOVAL , Torque Converter Clutch Assembly.>
  3. Remove the input shaft.
    Fig 1: Identifying Input Shaft
    G05002575Courtesy of SUBARU OF AMERICA, INC.
  4. Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
  5. Disconnect the inhibitor switch from the stay.
  6. Remove the oil charger pipe. < Ref. to REMOVAL , Oil Charge Pipe.>
  7. Remove the ATF inlet and outlet pipes. < Ref. to REMOVAL , ATF Cooler Pipe and Hose.>
  8. Separate the converter case from the transmission case. < Ref. to REMOVAL , Converter Case.>
  9. Remove the seal pipe.
  10. Remove the differential side retainers using ST.

    ST 18630AA010 WRENCH COMPL RETAINER

    NOTE:
    • WRENCH ASSY (499787000) can also be used.
    • Hold the differential case assembly by hand to avoid damaging the retainer mounting hole of the converter case.
  11. Remove the front differential assembly while being careful not to damage the attachment part of retainer.
scientia non olet · About LEMON Manuals