LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Forester XT, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4DOTC) >> Drive Cycle >> Procedure >> Drive Cycle H

Drive Cycle H

  1. Perform the Clear Memory Mode. < Ref. to CLEAR MEMORY MODE .>
  2. Read the engine coolant temperature, intake air temperature and fuel temperature with ignition switch ON. < Ref. to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , OPERATION, Subaru Select Monitor.>
  3. If the values from step  2) satisfy the following two conditions, start the engine.

    Condition: 

    |Engine coolant temperature - Intake air temperature| ≤ 5°C (41°F) 

    |Engine coolant temperature - Fuel temperature| ≤ 2°C (36°F) 

    NOTE:
    • If the value does not meet the conditions, turn the ignition switch to OFF and wait until it meets.
    • Start the engine in P range (AT model) or in N position (MT model).
  4. Idle the engine for one minute in the condition of step  3.
    ITEM CONDITION CHART

    DTC Item Condition
    *P1602 Control Module Programming Error -
scientia non olet · About LEMON Manuals