Non-Turbo Model

Install the water pump onto cylinder block (LH).
NOTE:
- Always use new gasket.
- When installing the water pump, tighten the bolts in two stages in alphabetical sequence as shown in figure.
Tightening torque:

First: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Second: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Fig 1: Identifying Water Pump Bolts Loosening Sequence In Alphabetical Order
Courtesy of SUBARU OF AMERICA, INC.
Install the hose to water pump.
Install the tensioner bracket.
Tightening torque: 25 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 2: Identifying Tensioner Bracket
Courtesy of SUBARU OF AMERICA, INC.
Install the belt cover No. 2 (LH).
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)

Fig 3: Identifying Belt Cover No. 2 (LH) Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the cam sprocket (LH) using ST.
ST 18231AA010 CAM SPROCKET WRENCH

NOTE: CAMSHAFT SPROCKET WRENCH (499207100) can also be used.

Tightening torque: 78 N.m (8.0 kgf-m, 57.9 ft-lb)

Fig 4: Removing Camshaft Sprocket By Using Special Tool
Courtesy of SUBARU OF AMERICA, INC.
Install the belt idler No. 2.
Tightening torque: 39 N.m (4.0 kgf-m, 28.9 ft-lb)

Fig 5: Identifying Belt Idler No. 2
Courtesy of SUBARU OF AMERICA, INC.
Install the automatic belt tension adjuster which has tension rod held by pin. <Ref. to AUTOMATIC BELT TENSION ADJUSTER ASSEMBLY AND BELT IDLER , INSTALLATION, Timing Belt.>
Install the timing belt. <Ref. to INSTALLATION , Timing Belt.>
Install the crank pulley. <Ref. to INSTALLATION , Crank Pulley.>
Install the V-belts. <Ref. to INSTALLATION , V-belt.>
Install the radiator. <Ref. to INSTALLATION , RADIATOR.>