LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> Outback i, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Diagnostics) (4AT) >> Subaru Select Monitor >> Operation >> Read Current Data

Read Current Data

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Transmission}.
  3. Select the [OK] after the information of transmission type is displayed.
  4. On the «Transmission Diagnosis» display screen, select the {Current Data Display & Save}.
  5. On the «Transmission Diagnosis» display screen, select the {Data Display}.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.

    A list of the support data is shown in the following table.

    SUPPORT DATA LIST

    Contents Display Unit of measure
    Battery voltage Battery Voltage V
    Rear vehicle speed sensor signal Rear Wheel Speed km/h or MPH
    Front vehicle speed sensor signal Front Wheel Speed km/h or MPH
    Engine speed signal Engine speed rpm
    Automatic transmission fluid temperature signal ATF Temp. °C or °F
    Accelerator pedal position sensor Throttle voltage V
    Gear position Gear Position -
    Line pressure control duty ratio Line Pressure Duty Ratio %
    Lock up clutch control duty ratio Lock Up Duty Ratio %
    Transfer clutch control duty ratio Transfer Duty Ratio %
    Accelerator pedal position sensor power supply Throttle sensor voltage V
    Torque converter turbine speed signal Turbine Revolution Speed rpm
    2 - 4 brake timing pressure control duty ratio Brake Clutch Duty Ratio %
    Low clutch duty ratio L/C Duty %
    High clutch duty ratio H/C Duty %
    Low & reverse brake duty ratio L&R/B Duty %
    Accelerator position Acceleration Opening Angle %
    FWD switch signal FWD SW ON or OFF
    Stop light switch signal Stop Light SW ON or OFF
    Anti lock brake system signal ABS signal ON or OFF
    Parking range signal P Range Signal ON or OFF
    Neutral range signal N Range Signal ON or OFF
    Reverse range signal R Range Signal ON or OFF
    Drive range signal D Range Signal ON or OFF
    AT diagnosis light output signal Diagnosis Light ON or OFF
    Cruise control signal Cruise Control Signal ON or OFF
    ATF temperature light ATF temperature light ON or OFF
    Up shift signal Up SW ON or OFF
    Down shift signal Down SW ON or OFF
    Sport mode signal Tiptronic Mode Switch ON or OFF
    Shift lock solenoid signal Shift Lock Solenoid ON or OFF
    NOTE: For details concerning operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".