Fuel Sub Level Sensor: Installation
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while being careful of the following.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align the protrusion (A) of gasket with the position shown in the figure.
- Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
- Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
NOTE:
Use a new gasket and retainer.
Tightening torque: 4.4 N.m (0.45 kgf-m, 3.2 ft-lb)