Clear Memory Mode: Operation: ECM

Select {Each System Check} in Main Menu.
On the «System Selection Menu» display screen, select the {Engine Control System}.
Select the [OK] after the information of engine type is displayed.
On the «Engine Diagnosis » display screen, select the {Clear Memory}.
When the «Done» is shown on the display screen, turn the ignition switch to OFF and close the Subaru Select Monitor.

NOTE:

After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait 3 seconds before starting the engine.
For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".