Converter Case: Installation

Check the appearance of each component and clean them.
Press-fit the oil seal to converter case using ST.
ST 499587100 OIL SEAL INSTALLER

Fig 1: Identifying Oil Seal To Converter Case
Courtesy of SUBARU OF AMERICA, INC.
Install the differential assembly to the case. < Ref. to INSTALLATION , Front Differential Assembly. >
Install the right and left side retainers. < Ref. to ADJUSTMENT , Front Differential Assembly. >
Apply proper amount of liquid gasket to the entire matching surface of converter case.
Liquid gasket: THREE BOND 1215 (Part No. 004403007)

Fig 2: Identifying Matching Surface Of Converter Case
Courtesy of SUBARU OF AMERICA, INC.
Install the converter case assembly without damaging bushing and oil seal.
Tightening torque: 41 N.m (4.2 kgf-m, 30.4 ft-lb)
Install the three converter case mounting bolts (TORX®).
ST 18676AA020 TORX® WRENCH

Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)

Fig 3: Identifying Converter Case Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire oil pan mating surface, and then install it.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)

Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb)

Fig 4: Identifying Oil Pan Mating Surface
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission harness connector to the stay.
Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
Install the ATF filter pipe. < Ref. to INSTALLATION , ATF Filter. >
Install the oil charge pipe with O-ring. < Ref. to INSTALLATION , Oil Charge Pipe. >
Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >