When Using Windshield Glass Knife
- Disconnect the wiper deicer connector. (Model with wiper deicer)
- Remove the cowl panel. <Ref. to REMOVAL , Cowl Panel.>
- Remove the glass molding.
- Tape the body side of the circumference of windshield glass for protection.
- Apply sufficient amount of soapy water to the adhesive part.
- Make a cut in the adhesive part using a putty knife so that windshield glass knife can be inserted easily.
- Insert the windshield glass knife into the adhesive.
- While holding the knife edge and windshield glass edge at a right angle, move the windshield glass knife in parallel to the windshield glass edge along the surface and edge of windshield glass to cut the adhesive part.
NOTE:
- Do not twist the windshield glass knife.
- Cutting of adhesive part shall be started with wider gap between windshield glass and body.
- The locating pins are bonded to the corners of glass. Use piano wire to disconnect the pins.