LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> Impreza Base, 4D Sedan, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Security And Locks) >> Security Control Unit >> Procedure >> Alarm History Report Mode

Alarm History Report Mode

WARNING: This page is about a different car, the 2006 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to ON.
  2. Security indicator light blinks.
    SECURITY INDICATOR LIGHT BLINKS CHART

    The number of times security indicator light blinks Vehicle state
    Once WARNING is activated by impact sensor (OP). It may be caused by light impact on outside of vehicle or other person's vandalism.
    2 times ALARM is activated by impact sensor (OP). It may be caused by strong impact on outside of vehicle or other person's vandalism.
    3 times The ignition switch has been turned to ON.
    4 times The rear gate has been opened.
    5 times One of the doors has been opened.
    NOTE:
    • If the ALARM/WARNING occurs in the ARM mode, the indicator light blinks when the ignition switch is turned to OFF → ON at the next DISARM mode.
    • If ALARM/WARNING does not occur, the light does not blink.
    • More than one alarm or warning occurs, the most numbers of blinking times have priority to blink.
    • Anytime the ignition switch is turned to ON in the DISARM mode, it blinks. The memory will be updated at the next ARM mode.
scientia non olet · About LEMON Manuals