LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> Impreza Base, 4D Sedan, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Security And Locks) >> Keyless Entry System >> Inspection >> Check Hazard Light Operation

Check Hazard Light Operation

WARNING: This page is about a different car, the 2006 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CHECK HAZARD LIGHT OPERATION

Step Check Yes No
1 CHECK HAZARD LIGHT OPERATION. 
Make sure the hazard light blinks when hazard switch is turned ON.		 Does the hazard light blink? Go to step 2.  Check the hazard light circuit.
2 CHECK OUTPUT SIGNAL. 
  1. Remove the key from ignition switch.
  2. Close all doors and rear gate.
  3. Measure the voltage between keyless entry control unit harness connector terminal and chassis ground when LOCK/ARM button of transmitter is pressed.

    Connector & terminal 

    (B176) No. 1,13 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Check the harness for open or short between keyless entry control unit and turn signal lights. Replace the keyless entry control unit.
scientia non olet · About LEMON Manuals