LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> Impreza Base, 4D Sedan, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Security And Locks) >> Keyless Entry System >> Inspection >> Check Buzzer Chirp Setting

Check Buzzer Chirp Setting

WARNING: This page is about a different car, the 2006 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CHECK BUZZER CHIRP SETTING

Step Check Yes No
1 CHECK BUZZER CHIRP SETTING. 
  1. Check the current setting of the buzzer chirp.
  2. Remove the key from the ignition switch.
  3. Close all doors and the rear gate.
  4. Press the LOCK/ARM or UNLOCK/DISARM button.
 Does the buzzer signal chirp? Buzzer chirp function is OK. Go to step 2. 
2 CHECK BUZZER CHIRP SETTING. 
  1. Open the driver's door, and remove the key from the ignition switch.
  2. Insert the key into ignition switch with the manual UNLOCK switch on vehicle side turned to ON.
  3. Repeat the procedure of removing --> inserting the key five times within 10 seconds from step  2).
  4. Perform opening --> closing the door within 5 seconds from the fifth procedure in step  3).
  5. Switch the setting (ON ←→ OFF) of answer back buzzer. The hazard light will blink three times.
    NOTE: If not performing opening --> closing the door within 10 seconds, the hazard light will blink once. In that case, perform the procedure from the beginning again.
  6. Press the LOCK/ARM or UNLOCK/DISARM button.
 Does the buzzer signal chirp? Buzzer chirp function is OK. Check the transmitter function. < Ref. to CHECK TRANSMITTER BATTERY AND FUNCTION , INSPECTION, Keyless Entry System. >
scientia non olet · About LEMON Manuals