Select Cable: Installation

WARNING: This page is about a different car, the 2007 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the select cable to plate assembly.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)
Install the select cable to select lever.
Install the plate assembly to the transmission.
Tightening torque:

T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 1: Identifying Select Cable And Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Install the washer and snap pin to range select lever.

Fig 2: Identifying Washer And Snap Pin
Courtesy of SUBARU OF AMERICA, INC.
Move the select lever to the "N" range, then adjust the select cable position. <Ref. to ADJUSTMENT Select Cable. >
Install the heat shield cover. (If equipped)
Install the front and center exhaust pipe. Non-turbo model
<Ref. to INSTALLATION Front Exhaust Pipe. >

Turbo model

<Ref. to INSTALLATION Front Exhaust Pipe. >