Converter Case: Installation

Check the appearance of each component and clean them.
Press-fit the oil seal to converter case using ST.
ST 499587100 OIL SEAL INSTALLER

Fig 1: Identifying Oil Seal
Courtesy of SUBARU OF AMERICA, INC.
Install the differential assembly to the case. <Ref. to INSTALLATION , Front Differential Assembly .>
Install the right and left side retainers. <Ref. to ADJUSTMENT , Front Differential Assembly .>
Apply proper amount of liquid gasket to the entire matching surface of converter case.
Liquid gasket:

THREE BOND 1215 (Part No. 004403007)

Fig 2: Identifying Matching Surface Of Converter Case
Courtesy of SUBARU OF AMERICA, INC.
Install the converter case assembly without damaging bushing and oil seal.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)
Install the three converter case mounting bolts (TORX®).
ST 18676AA020 TORX® WRENCH

Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)

Fig 3: Identifying Converter Case Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire oil pan mating surface, and then install it.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020)

Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)

Fig 4: Identifying Oil Pan Mating Surface
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission harness connector to the stay.
Install the air breather hose. <Ref. to INSTALLATION , Air Breather Hose .>
Install the ATF filter pipe. <Ref. to INSTALLATION , ATF Cooler Pipe and Hose .>
Install the oil charge pipe with O-ring. <Ref. to INSTALLATION , Oil Charge Pipe .>
Install the torque converter assembly. <Ref. to INSTALLATION , Torque Converter Assembly .>
Install the transmission assembly to the vehicle, <Ref. to INSTALLATION , Automatic Transmission Assembly .>