LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Tilt Steering Column >> Installation

Tilt Steering Column: Installation

  1. Insert the end of the steering shaft into the toe board.
  2. With the tilt lever secured, tighten the steering shaft mounting bolts under instrument panel.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.1 ft-lb) 

  3. Connect all the connectors under the instrument panel.
  4. Connect the airbag system connector at the harness spool.
    NOTE: Make sure to apply double lock.
  5. Install the instrument panel lower cover with tilt lever held in the lowered position.
  6. Install the universal joint. < Refer to INSTALLATION , UNIVERSAL JOINT. >
  7. Align the center position of the roll connector. < Refer to ADJUSTMENT , Roll Connector. >
  8. Install the steering wheel. < Refer to INSTALLATION , STEERING WHEEL. >
    CAUTION: Insert the roll connector guide pin into the guide hole on lower end of steering wheel surface to prevent damage.
scientia non olet · About LEMON Manuals