Drive Cycle H

1. Perform the Clear Memory Mode. <Ref. to CLEAR MEMORY MODE . >
2. With the ignition switch ON, read the engine coolant temperature, intake air temperature and fuel temperature. <Ref. to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , Operation, Subaru Select Monitor.>
3. If the values from step  2) satisfy the following two conditions, start the engine.

   Condition: 

   Engine coolant temperature - intake air temperature <5°C (41 °F) 

   Engine coolant temperature - fuel temperature <2°C (36°F) 

   NOTE:

   • If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied.
   • Start AT vehicles in the P range, and MT vehicles in the N position.
   • Idle the engine for 1 minute under the conditions in step  2).

Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)