Registration Of Keyless Transmitter With SUBARU Select Monitor

NOTE:

A maximum of four keyless transmitter can be registered for each individual vehicle.
When replacing or adding the keyless transmitter, new registration of transmitter is necessary.

Connect the Subaru Select Monitor to the vehicle.
Turn the ignition switch to ON.
From the «Main menu» on the Subaru Select Monitor, select the {2. Check individual system} ↓ {7. Integrated unit mode} ↓ {8. Transmitter ID registration}, and press the [YES] key.
Input the 8-digit ID number fund inside the plastic bag that the transmitter came in, or inside the transmitter, from left to right. Press the [YES] key.
NOTE: Press the [upper filled triangle] key on the Subaru Select Monitor to increase the number, and the [lower filled triangle] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.
The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag.
Press the [YES] key if the ID number is correct. Press the [NO] key if incorrect, to return to the step 3 and try again.
«ID registration in process...» is displayed and registration starts.
«ID registration done» will be displayed when the registration process is done.
To exit, select «END:NO», and press the [NO] key to return to {8. Transmitter ID registration}. If there are additional transmitters to be registered, select «Next registration: YES», and press the [YES] key to return to the step 3).
NOTE:
- If the registration fails, «ID registration failed. Try again.» will be shown. Press the [YES] key to return to the {8. Transmitter ID registration}. Retry from step 2.
- «END: NO» is shown on the Subaru Select Monitor when fourth keyless transmitter has been registered. Press the [NO] key to return to {8. Transmitter ID registration}.