LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Outback i, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Mechanical (H4SO)) >> Valve Rocker Assembly >> Installation

Valve Rocker Assembly: Installation

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation of valve rocker assembly
    1. Temporarily tighten bolts (a) through (d) in alphabetical order equally as shown in figure.
      NOTE: Do not allow valve rocker assembly to damage knock pins.
    2. Tighten bolts (e) through (h) in alphabetical order to specified torque.
    3. Tighten bolts (a) through (d) in alphabetical order to specified torque.

      Tightening torque: 

      25 N.m (2.5 kgf-m, 18.1 ft-lb) 

      Fig 1: Identifying Valve Rocker Assembly Bolts
      G04988315Courtesy of SUBARU OF AMERICA, INC.
  2. Adjust the valve clearances. < Ref. to ADJUSTMENT , Valve Clearance. >
  3. Install rocker cover and connect PCV hose.
  4. Install camshaft sprocket. < Ref. to INSTALLATION , CAMSHAFT SPROCKET. >
  5. Install timing belt. < Ref. to INSTALLATION , Timing Belt. >
  6. Install timing belt cover. < Ref. to INSTALLATION , TIMING BELT COVER. >
  7. Install crankshaft pulley. < Ref. to INSTALLATION , CRANKSHAFT PULLEY. >
  8. Install V-belt. < Ref. to INSTALLATION , V-BELT. >
scientia non olet · About LEMON Manuals