Section 31 (Cruise Control System): Actuator: Removal
WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be careful not to apply excessive load to the wire cable when adjusting and/or installing; otherwise, the actuator may be deformed or damaged.
- Do not bend cable sharply with a radius less than 100 mm (3.94 in); otherwise, cable may bend permanently, resulting in poor performance.
- When installing cable, be careful not to sharply bend or pinch the inner cable; otherwise, the cable may break.
- Disconnect ground cable from battery.
- Remove clip bands from cruise control cable.
- Loosen nut which secures cruise control cable end to throttle cam and then remove cable from throttle cam.
- Remove actuator attaching bolts.
- Remove actuator while disconnecting connector.