Section 31 (Cruise Control System): Actuator: Installation
WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal.
Tightening torque:
Actuator
7.4 N.m (0.75 kgf-m, 5.4 ft-lb)
Cable end nut
12 N.m (1.2 kgf-m, 8.7 ft-lb)
NOTE:
(A): Must be adjusted when cable end outer is fixed in place, so that gap between throttle cam and lever is 0 - 1 mm (0 - 0.04 in), or inner cable deflection (D) is 1 - 8 mm (0.039 - 0.315 in) with specified range of throttle cable play.
(Must be attached while throttle cam is being pulled by wire cable.)
(B): Must be coated evenly on cam end inner connection.
(C): Cover must be inserted securely, until tip of cable touches cover stopper.
(Must be attached while throttle cam is being pulled by wire cable.)
(B): Must be coated evenly on cam end inner connection.
(C): Cover must be inserted securely, until tip of cable touches cover stopper.