Status Data Display

Check the operating condition of each sensor in the event of malfunction in seat belt buckle switch and seat position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.

On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Airbag System} and press the [YES] key.

On the «Airbag System» display screen, select the {Status Data} and press the [YES] key.

The support data is shown in the following table.

STATUS DATA

Item

Contents of diagnosis

Seat position sensor LH

Front ⁽¹⁾/Rear⁽²⁾/Other⁽³⁾/Unknown⁽³⁾/-⁽⁵⁾

Seat position sensor RH

-⁽⁵⁾

Seat belt buckle switch LH

Belted⁽⁶⁾/Unbelted⁽⁷⁾/Other⁽⁸⁾/Unknown⁽⁴⁾/-⁽⁹⁾

Seat belt buckle switch RH

Belted⁽⁶⁾/Unbelted⁽⁷⁾/Other⁽⁸⁾/Unknown⁽⁴⁾/-⁽⁹⁾

Passenger's airbag status

ON⁽¹⁰⁾/OFF⁽¹¹⁾/Unknown⁽⁴⁾

⁽¹⁾	The seat position is forward.

⁽²⁾	The seat position is rearward.

⁽³⁾	It is displayed when data other than forward and backward positions of the seat, such as malfunction etc., is input.

⁽⁴⁾	It is displayed at the initial status.

⁽⁵⁾	Seat position sensor is not available.

⁽⁶⁾	Seat belt is fastened.

⁽⁷⁾	Seat belt is unfastened.

⁽⁸⁾	It is displayed when data other than fastened or unfastened belts, such as malfunction etc., is input.

⁽⁹⁾	Seat belt buckle switch is not available.

⁽¹⁰⁾	Passenger's airbag is active.

⁽¹¹⁾	Passenger's airbag is not active.

NOTE: For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.