LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (A/T Control Systems) >> Select Cable >> Removal

Select Cable: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set the vehicle on a lift.
  2. Set the select lever to "N" range.
  3. Disconnect negative cable from battery.
  4. Lift-up the vehicle.
  5. Remove front, center, rear exhaust pipe and muffler. (SOHC model)

    < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Center Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

  6. Remove the center and rear exhaust pipes and muffler. (DOHC turbo model)

    < Ref. to REMOVAL , Center Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

  7. Remove the snap pin and washer from range select lever.
    Fig 1: Identifying Snap Pin And Washer
    G05002303Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from transmission case.
    Fig 2: Identifying Select Cable, Plate ASSY And Clamp
    G05002304Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the cable from select lever, and then remove the cable bracket.
    Fig 3: Identifying Adjusting Nuts And Cable Bracket
    G05002305Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the select cable from plate assembly.
scientia non olet · About LEMON Manuals