LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Impreza Outback Sport, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Front Vehicle Speed Sensor >> Removal

Front Vehicle Speed Sensor: Removal

  1. Set up the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Remove the air intake chamber. (Non-turbo model) < Ref. to REMOVAL , Air Intake Chamber. >
  4. Remove the intercooler. (Turbo model)

    < Ref. to REMOVAL , Intercooler. >

  5. Disconnect the transmission connector.
    Fig 1: Identifying Transmission Connector
    G05002525
  6. Remove the pitching stopper. < Ref. to REMOVAL , Transmission Mounting System. >
  7. Remove the transmission connector from stay.
  8. Lift-up the vehicle.
  9. Clean the transmission exterior.
  10. Drain the ATF completely.
    NOTE:
    • Tighten the ATF drain plug after draining the ATF.
    • Use a new gasket.

    Tightening torque: 25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    Fig 2: Identifying Oil Pan And Drain Plug (ATF)
    G05002526
  11. Remove the front, center, exhaust pipes and muffler. (Non-turbo model)

    < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

  12. Remove the center, rear exhaust pipe and muffler. (Turbo model)

    < Ref. to REMOVAL , Center Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

  13. Remove the propeller shaft. < Ref. to REMOVAL , Propeller Shaft. >
  14. Place the transmission jack under transmission.
    NOTE: Make sure that the support plates of transmission jack don't touch the crossmember.
  15. Remove the transmission rear crossmember bolts.
    Fig 3: Locating Transmission Rear Crossmember Bolts
    G05002527
  16. Lower the AT jack.
    NOTE: Do not separate the AT jack and transmission.
  17. Remove the oil cooler inlet and outlet pipe.
    NOTE: When removing the outlet pipe, be careful not to lose balls and springs used with retaining screws.
  18. Remove the front and torque converter turbine speed sensor.
    Fig 4: Identifying Front Vehicle Speed Sensor And Torque Converter Turbine Speed Sensor
    G05002528
  19. Disconnect the connector of rear vehicle speed sensor. (VTD model)
    Fig 5: Identifying Rear Vehicle Speed Sensor
    G05002529
  20. Disconnect the connector from rear vehicle speed sensor. (MP-T model)
    Fig 6: Identifying Rear Vehicle Speed Sensor
    G05002530
  21. Remove the oil pan.
  22. Disconnect the harness connector and transmission ground terminal.
    Fig 7: Identifying Transmission Ground And Harness Connector
    G05002531
  23. Remove the harness assembly.
scientia non olet · About LEMON Manuals