LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Impreza Outback Sport, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Control Valve Body >> Removal

Control Valve Body: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Lift-up the vehicle.
  4. Clean the transmission exterior.
  5. Remove the drain plug and gasket, and then drain ATF.
    Fig 1: Identifying Drain Plug
    G05002544
  6. Replace the gasket with a new one, and then tighten the drain plug.

    Tightening torque: 25 N.m (2.5 kgf-m, 18.4 ft-lb) 

  7. Remove the oil pan.
    CAUTION: Be careful not to allow dirt or dust to get into the oil pan.
    Fig 2: Identifying Oil Pan
    G05002545
  8. Remove the magnet.
    Fig 3: Identifying Magnet
    G05002546
  9. Clean the magnet.
  10. Remove the liquid gasket completely from oil pan and transmission case.
  11. Remove the control valve connector.
    Fig 4: Identifying Control Valve Connector
    G05002547
  12. Remove the oil cooler pipe.
    Fig 5: Identifying Oil Cooler Pipe
    G05002548
  13. Remove the control valve body.
    NOTE: Replace the control valve body as assembly, because the control valve body can not be disassembled.
    Fig 6: Identifying Control Valve Body
    G05002549
scientia non olet · About LEMON Manuals