Rear Oxygen Sensor: Installation

Before installing rear oxygen (A/F) sensor, apply the anti-seize compound only to the threaded portion of rear oxygen (A/F) sensor. This facilitates the next removal.
CAUTION: Never apply anti-seize compound to protector of rear oxygen sensor.

Anti-seize compound:

NEVER-SEEZ NS-165 or the equivalent
Install the rear oxygen sensor.
Tightening torque:

21 N.m (2.1 kgf-m, 15.2 ft-lb)

Fig 1: Locating Rear Oxygen Sensor
- AT model
Fig 2: Locating Rear Oxygen Sensor (AT Model)
- MT model
Fig 3: Locating Rear Oxygen Sensor (MT Model)
Connect the connector to rear oxygen sensor.

Fig 4: Locating Rear Oxygen Sensor Connector
Connect the clip to the crossmember.

Fig 5: Locating Clip
Lower the vehicle.
Connect the ground cable to battery.

Fig 6: Disconnecting Battery Ground Cable