Read Current Data
- On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Transmission Control System} and press the [YES] key.
- Press the [YES] key after the information of transmission type is displayed.
- On the «Transmission Diagnosis» display screen, select the {Current Data Display & Save} and press the [YES] key.
- On the «Transmission Diagnosis» display screen, select the {Data Display} and press the [YES] key.
- Using the scroll key, scroll the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.
DIAGNOSIS PROCEDURE
| Contents | Display | Unit of measure |
|---|---|---|
| Battery voltage | Battery Voltage | V |
| Rear vehicle speed sensor signal | Rear Wheel Speed | km/h or MPH |
| Front vehicle speed sensor signal | Front Wheel Speed | km/h or MPH |
| Engine speed signal | Engine Speed | rpm |
| ATF temperature | ATF Temp. | °C or (°F) |
| Gear position | Gear Position | - |
| Line pressure control duty ratio | Line Pressure Duty Ratio | % |
| Lock up clutch duty ratio | Lock Up Duty Ratio | % |
| Transfer clutch duty ratio | Transfer Duty Ratio | % |
| Torque converter turbine speed signal | Turbine Revolution Speed | rpm |
| 2-4 brake duty ratio | Brake Clutch Duty Ratio | % |
| Low clutch duty ratio | L/C Duty | % |
| High clutch duty ratio | H/C Duty | % |
| Low & reverse brake duty ratio | L&R/B Duty | % |
| Accelerator position | Accel. Opening Angle | % |
| ATF temperature lamp | ATF temperature lamp | ON or OFF |
| Stop light switch signal | Stop light switch | ON or OFF |
| Parking range signal | P Range Signal | ON or OFF |
| Neutral range signal | N Range Signal | ON or OFF |
| Reverse range signal | R Range Signal | ON or OFF |
| Drive range signal | D Range Signal | ON or OFF |
| 3rd range signal | 3rd Range Signal | ON or OFF |
| 2nd range signal | 2nd Range Signal | ON or OFF |
| 1st range signal | 1st Range Signal | ON or OFF |
| AT diagnosis light output signal | Diagnosis Lamp | ON or OFF |
| FWD switch signal | FWD SW | ON or OFF |
| Shift lock solenoid signal | Shift lock solenoid | ON or OFF |
| Cruise control signal | Cruise Control Signal | ON or OFF |
NOTE:
For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL
".