LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester X, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Abs >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor

Abs Sequence Control With SUBARU Select Monitor

NOTE: If a problem occurs, sequence control will not operate. In this case, diagnose the failure. <Ref. to PROCEDURE Basic Diagnostic Procedure. >
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch ON.
  3. Subaru Select Monitor to ON.
  4. Set the Subaru Select Monitor to "Brake Control" mode.
  5. When the "Function check sequence" is selected, the "ABS sequence control" will start.
  6. Execute the following operations when the message "Press the brake pedal so that the brake pedal force is between 100 and 150 kgf" is displayed.
    1. When using a brake tester, press the brake pedal pad with a force of 981 N (100 kgf, 221 lb).
    2. When using a pressure gauge, press the brake pedal so that the pressure gauge indicates 3,432 kPa (35 kg/cm2 , 498 psi).
      CAUTION: On models with the hill holder feature, do not step on the clutch pedal.
  7. "Press the [YES] key" will be displayed. Press the YES key.
  8. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals