LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester X L.L. Bean Edition >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4SO) >> Inspection Mode >> Procedure >> SUBARU Select Monitor

SUBARU Select Monitor

  1. After clearing the memory, check for any remaining unresolved trouble data. <Ref. to CLEAR MEMORY MODE . >
  2. Warm up the engine.
  3. Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL  GENERAL DESCRIPTION. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013
  4. Connect the diagnosis cable to Subaru Select Monitor.
  5. Insert the cartridge to Subaru Select Monitor. <Ref. to PREPARATION TOOL  GENERAL DESCRIPTION. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014
  6. Connect the test mode connector (A) at the lower portion of instrument panel (on the driver's side).
    Fig 3: Identifying Test Mode Connector
    G04993022
  7. Connect the Subaru Select Monitor to data link connector.
    1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
      Fig 4: Locating Data Link Connector
      G04997584
    2. Connect the diagnosis cable to data link connector.
      CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
  8. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
    Fig 5: Identifying Power Switch
    G04993024
  9. On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
  10. On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
  11. Press the [YES] key after the information of engine type has been displayed.
  12. On the «Engine Diagnosis» display screen, select the {Dealer Check Mode Procedure} and press the [YES] key.
  13. When the "Perform Inspection (Dealer Check) Mode " is shown on the screen, press the [YES] key.
  14. Perform subsequent procedures as instructed on the display screen.
NOTE:
  • For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
  • For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".

    <Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >

  • Release the parking brake.
  • The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of self-diagnosis system.
scientia non olet · About LEMON Manuals