LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> B9 Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Drive Cycle >> Procedure >> Drive Cycle E

Drive Cycle E

  1. Check that the battery voltage is over 10.9 V.
  2. Perform the clear memory mode. < Refer to CLEAR MEMORY MODE . >
  3. Drive for approximately 30 (7.9 US gal, 6.6 Imp gal) of fuel.
NOTE:
  • It is acceptable to drive the vehicle intermittently.
  • Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
DIAGNOSTIC CHART

DTC Item On condition
P0461 Fuel Level Sensor Circuit Range/Performance -