LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback XT, Standard >> Repair and Diagnosis >> Transmission >> Clutch >> Clutch System >> Clutch Switch >> Inspection

Clutch Switch: Inspection

  1. Confirm that the engine does not start when the clutch pedal is released. If the engine starts, adjust the clutch switch and inspect the starter interlock circuit.
  2. Confirm that the engine starts when the clutch pedal is fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock circuit.
  3. Check the clutch switch continuity. If continuity is not as specified, replace the switch.
    1. Disconnect the clutch switch connector.
    2. Measure the resistance between No. 1 and 2 of switch terminal.
    TERMINAL CONNECTOR SPECIFICATION CONDITION CHART

    Condition Terminal No. Specified resistance
    When clutch pedal depressed No. 1 - No. 2 Less than 1 Ω
    When clutch pedal not depressed No. 1 - No. 2 More than 1 MΩ

    Clutch switch (Starter interlock)

    Fig 1: Identifying Clutch Switch (Starter Interlock) Connector
    G03832255Courtesy of SUBARU OF AMERICA, INC.

    Clutch switch (Cruise control)

    Fig 2: Identifying Clutch Switch (Cruise Control) Connector
    G03832256Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals