LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback XT, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Security System >> Inspection >> Check Hazard Light Operation

Check Hazard Light Operation

STEP CHECK SHEET

Step Check Yes No
1. CHECK HAZARD LIGHT OPERATION. 

Make sure the hazard light blinks when hazard switch is turned to ON.

 Does the hazard light blink? Go to step 2.  Check the hazard light circuit.
2. CHECK OUTPUT TO HAZARD LIGHT. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the key warning switch harness connector.
  3. Connect the Subaru Select Monitor to data link connector.
  4. Turn the ignition switch to ON.
  5. Select {body integrated module} from main menu.
  6. Select the {ECM customizing}.
  7. Check the {Hazard answer-back setup}, and then switch to ON setting.
  8. Select {Current Data Display & Save}.
  9. When operating the LOCK/UNLOCK button of transmitter, check the hazard output signal of body integrated unit.
 Is output signal is present when operating the transmitter LOCK/UNLOCK button? Go to step 3.  Check the body integrated unit. < Ref. to , BASIC DIAGNOSTIC PROCEDURE . >
3. CHECK CIRCUIT OF HAZARD LIGHT. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the harness connector of body integrated unit.
  3. Disconnect the turn signals hazard unit harness connector.
  4. Measure the resistance between harness connector terminals.

Connector & terminal 

(B280) No. 12 - (B32) No. 8: 

 Is the resistance less than 10 Ω? Check the body integrated unit. < Ref. to , BASIC DIAGNOSTIC PROCEDURE . > Repair the harness.
scientia non olet · About LEMON Manuals