LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback XT, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Keyless Entry System >> Inspection >> Check Ignition Switch Illumination

Check Ignition Switch Illumination

STEP CHECK SHEET

Step Check Yes No
1. CHECK FUSE. 

Remove and visually check the fuse No. 14 (in the main fuse box).

 Is the fuse blown out? Replace the fuse with a new one. Go to step 2. 
2. CHECK POWER SUPPLY. 
  1. Disconnect the ignition switch illumination harness connector.
  2. Measure the voltage between the harness connector terminal and chassis ground.

Connector & terminal 

(B224) No. 2 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Go to step 3.  Check the harness for open circuits and shorts between the ignition switch illumination and fuse.
3. CHECK IGNITION SWITCH ILLUMINATION CIRCUIT. 
  1. Disconnect the harness connector of body integrated unit and ignition switch illumination harness connector.
  2. Measure the resistance between body integrated unit harness connector terminal and ignition switch illumination harness connector terminal.

Connector & terminal 

(B280) No. 4 - (B224) No. 1: 

 Is the resistance less than 10 Ω? Replace the ignition switch illumination bulb with a new one. < Ref. to REMOVAL , Ignition Switch Illumination. > Check the harness for open circuits and shorts between the body integrated unit and ignition switch illumination.
scientia non olet · About LEMON Manuals