LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback XT, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Abs >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor

Abs Sequence Control With SUBARU Select Monitor

NOTE: In the event of any trouble, the ABS sequence control is not operated.
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Set the Subaru Select Monitor switch to ON.
  4. Set the Subaru Select Monitor to "Brake Control" mode.
  5. When the "Function check sequence" is selected, the "ABS sequence control" will start.
  6. Execute the following operations when the message "Press the brake pedal so that the brake pedal force is between 100 and 150 kgf" is displayed.
    1. When the brake tester is used, press brake pedal pad with a force of 1,000 N (102 kgf, 225 lb).
    2. When using the pressure gauge, press the brake pedal so as to make the pressure gauge indicate 3,500 kPa (36 kg/cm2 , 511 psi).
  7. "Press the [YES] key" will be displayed. Press the [YES] key.
  8. The brake line being operated is displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals