LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Lubrication (H4SO)) >> Oil Pressure System >> Inspection

Oil Pressure System: Inspection

WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
INSPECTION STEP

Step Check Yes No
1. CHECK COMBINATION METER. 
  1. Turn ignition switch to ON. (engine OFF)
  2. Check other warning lights.
 Does the warning lights go on? Go to step 2.  Repair or replace the combination meter. < Ref. to INSPECTION , Combination Meter System. >
2. CHECK HARNESS CONNECTOR BETWEEN COMBINATION METER AND OIL PRESSURE SWITCH. 
  1. Turn ignition switch to OFF.
  2. Disconnect connector from the oil pressure switch.
  3. Turn ignition switch ON.
  4. Measure the voltage of harness between the combination meter connector and chassis ground.

Connector & terminal 
(E11) No. 1 - Chassis ground: 		 Is the measured value more than 10 V? Replace oil pressure switch. Go to step 3. 
3. CHECK COMBINATION METER. 
  1. Turn ignition switch to OFF.
  2. Remove the combination meter.
  3. Measure the resistance of the combination meter.

Terminal 
No. 13 - No. 3: 		 Is the measured value less than 10 Ω? Replace the harness connector between combination meter and oil pressure switch. Repair or replace the combination meter and the oil pressure switch warning light bulb.
scientia non olet · About LEMON Manuals