LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Clear Memory Mode >> Operation >> SUBARU Select Monitor (OBD Mode)

SUBARU Select Monitor (OBD Mode)

  1. On the << Main Menu>> display screen, select the {Each System Check} and press the [YES] key.
  2. On the << System Selection Menu>> display screen, select the {Engine} and press the [YES] key.
  3. Press the [YES] key after the information of engine type was displayed.
  4. On the << Engine Diagnosis>> display screen, select the {OBD System} and press the [YES] key.
  5. On the << OBD Menu>> display screen, select the {DTC Clear} and press the [YES] key.
  6. When the "Perform Diagnostic Code(s) Clear?" is shown on the screen, press the [YES] key.
  7. Turn the ignition switch to OFF and then turn off the Subaru Select Monitor.
NOTE:
  • Initial diagnosis of electronic control throttle is performed after memory clearance. For this reason, start the engine after 10 seconds or more have elapsed since the ignition switch was turned to ON.
  • For detailed operation procedure, refer to the generic scan tool instruction cards, refer to the SUBARU SELECT MONITOR OPERATION MANUAL .
scientia non olet · About LEMON Manuals