LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback Limited, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Automatic Transmission) >> Center Differential Carrier >> Assembly

Center Differential Carrier: Assembly

WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the thrust washer onto the intermediate shaft.
  2. Install thrust bearing onto the intermediate shaft.
  3. Install the pinion gears and washers.
  4. Insert the shaft into the center differential assembly.
  5. Install the snap ring.
  6. Using a press, install a new ball bearing into the center differential assembly.

    ST 498077000 REMOVER

    Fig 1: Installing Ball Bearing Into Center Differential Assembly Using Remover ST498077000
    G03750605Courtesy of SUBARU OF AMERICA, INC.
  7. Apply Vaseline onto the seal ring outer surface and shaft grooves.
  8. Install new seal rings.
scientia non olet · About LEMON Manuals