Read Freeze Frame Data For Engine (OBD Mode)
- On << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
- On << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
- Press the [YES] key after the information of engine type is displayed.
- On << Engine Diagnosis >> display screen, select the {OBD System} and press the [YES] key.
- On << OBD Menu >> display screen, select the {Freeze Frame Data} and press the [YES] key.
- A list of support data is shown in SUPPORT DATA
.SUPPORT DATA
Contents Display Unit of measure DTC for freeze frame data Freeze frame data DTC Air fuel ratio control system for bank 1 Fuel system for Bank 1 ON or OFF Engine load data Engine Load % Engine coolant temperature signal Coolant Temp. °C or °F Short term fuel trim by front oxygen (A/F) sensor Short term fuel trim B1 % Long term fuel trim by front oxygen (A/F) sensor Long term fuel trim B1 % Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg, kPa, inHg or psi Engine speed signal Engine Speed RPM Vehicle speed signal Vehicle Speed km/h or MPH Ignition timing signal Ignition Timing ° Intake air volume Mass Air Flow g/sec Intake air temperature signal Intake Air Temp °C Throttle position signal Throttle Opening Angle % Oxygen sensor #12 Oxygen sensor #12 V A/F correction #12 Short term fuel trim #12 % Oxygen sensor #11 Oxygen sensor #11 Support Oxygen sensor #12 Oxygen sensor #12 Support
- A list of support data is shown in SUPPORT DATA
.
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.