LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Security System >> Inspection >> Basic Diagnostic Procedure >> With immobilizer model

With immobilizer model

BASIC DIAGNOSTIC PROCEDURE (WITH IMMOBILIZER MODEL)

Step Check Yes No
1 CHECK VALET MODE SETTING. 
Check the valet mode is set. (Security indicator light blinks two times per a second when the valet mode is set.)		 Does the security indicator light blink two times per a second? Go to step 2  . Go to step 3  .
2 RELEASE VALET MODE SETTING. 
Release the valet mode setting.
  1. Open the driver's door.
  2. Push the UNLOCK/DISARM button on keyless transmitter for two seconds or more.
  3. Check for the status of blinking for security indicator light.
 Does the security indicator light blink one time per three seconds? Go to step 3  . Go to symptom 1. < Ref. to SYMPTOM CHART , INSPECTION, Security System. >
3 CHECK SECURITY SYSTEM SET OPERATION. 
  1. Before starting this diagnosis, open all windows.
  2. Remove the key from ignition key cylinder, and then close all doors and rear gate.
  3. Press the LOCK/ARM button of keyless transmitter.
 Can the security system be set? Go to step 4  . Go to symptom 1. < Ref. to SYMPTOM CHART , INSPECTION, Security System. >
4 CHECK HAZARD LIGHT AND SECURITY INDICATOR LIGHT BLINKING. 
Check the status of blinking for both hazard light and security indicator light blinking.		 Does the hazard light blink, and the security indicator light blink twice per two seconds? Go to step 5  . Go to symptom 2. < Ref. to SYMPTOM CHART , INSPECTION, Security System. >
5 CHECK SECURITY ALARM OPERATION. 
  1. Unlock all doors using the door lock switch on front door.
  2. Open any door, trunk lid or rear gate.
 Does the security alarm operate when any door, trunk lid or rear gate is opened? Go to step 6  . Go to symptom 3. < Ref. to SYMPTOM CHART , INSPECTION, Security System. >
6 CHECK SECURITY ALARM OPERATION. 
Check the security alarm operation.		 Does all security alarm (horn, hazard light and security indicator light) operate? And is the starter motor deactivated? Go to step 7  . Go to symptom 4. < Ref. to SYMPTOM CHART , INSPECTION, Security System. >
7 CHECK SECURITY ALARM CANCEL OPERATION. 
  1. Press the UNLOCK/DISARM button of keyless transmitter to stop all the security alarm.
  2. Check for the status of blinking for security indicator light, and starter motor operation.
 Does the security indicator light blink once per three seconds? And is the starter motor activated? Go to step 8  . Go to symptom 5. < Ref. to SYMPTOM CHART , INSPECTION, Security System. >
8 CHECK BATTERY DISCONNECT PROTECTION. 
Check the battery disconnect protection. < Ref. to CHECK BATTERY DISCONNECT PROTECTION , INSPECTION, Security System. >		 Is the battery disconnect protection OK? Go to step 9  . Replace the security control unit.
9 PERFORM IMPACT SENSITIVITY TEST. 
Perform the impact sensitivity test. < Ref. to IMPACT SENSITIVITY TEST , INSPECTION, Security Control Unit. >		 Is the impact sensitivity properly set? Press the UNLOCK/DISARM button of keyless transmitter, and finish the diagnosis. Adjust the impact sensitivity. < Ref. to IMPACT SENSITIVITY , ADJUSTMENT, Security Control Unit. >
scientia non olet · About LEMON Manuals