LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Forester X, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Security And Locks) >> Body Integrated Unit >> Removal

Body Integrated Unit: Removal

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If replacing the body integrated unit, check the current setting and note it. < Ref. to CONFIRMATION OF CURRENT SETTING , OPERATION, Subaru Select Monitor. >
  • When replacing the body integrated unit, all immobilizer keys also must be replaced and registered again.
  1. Disconnect the ground cable from battery.
  2. Remove the instrument panel lower panel on driver's side. < Ref. to REMOVAL , Instrument Panel Assembly. >
  3. Disconnect the connector of body integrated unit.
    CAUTION: Be careful to keep water and other foreign materials away from body integrated unit.
  4. Remove the body integrated unit from the body integrated unit mounting bracket using flat tip screwdriver.
    CAUTION: Be careful not to damage the unit when removing it forcibly from the bracket.
  5. Remove the clutch pedal stopper arm. (MT model) < Ref. to REMOVAL , Clutch Pedal. >
  6. Remove two body integrated unit bracket mounting bolts, and remove the bracket.
Fig 1: Removing Two Body Integrated Unit Bracket Mounting Bolts
G03833911Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals