LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Turbo, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4DOTC) >> Subaru Select Monitor >> Operation >> Read Current Data For Engine. (OBD Mode)

Read Current Data For Engine. (OBD Mode)

  1. On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
  2. On the << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after the information of engine type is displayed.
  4. On the << Engine Diagnosis >> display screen, select the {OBD System} and press the [YES] key.
  5. On the << OBD Menu >> display screen, select the {Current Data Display & Save} and press the [YES] key.
  6. On the << Data Display Menu >> display screen, select the {Data Display} and press the [YES] key.
  7. Using the scroll key, move the display screen up or down until desired data is shown.
    • A list of the support data is shown in the following table.
      SUPPORT DATA LIST

      Contents Display Unit of measure
      Number of DTC Number of DTC -
      Malfunction indicator light status MI (MIL) ON or OFF
      Monitoring test of misfire Misfire monitoring Complete or incomplete
      Monitoring test of fuel system Fuel system monitoring Complete or incomplete
      Monitoring test of comprehensive component Component monitoring Complete or incomplete
      Test of catalyst Catalyst Diagnosis Complete or incomplete
      Test of heated catalyst Heated catalyst No support
      Test of evaporative emission purge control system Evaporative purge system Complete or incomplete
      Test of secondary air system Secondary air system No support
      Test of air conditioning system refrigerant A/C system refrigerant No support
      Test of oxygen sensor Oxygen sensor Complete or incomplete
      Test of oxygen sensor heater O2 Heater Diagnosis Complete or incomplete
      Test of EGR system EGR system No support
      Air fuel ratio control system for bank 1 Fuel System for Bank 1 -
      Engine load data Calculated load value %
      Engine coolant temperature signal Coolant Temp. °C or °F
      Short term fuel trim by front oxygen (A/F) sensor Short term fuel trim B1 %
      Long term fuel trim by front oxygen (A/F) sensor Long term fuel trim B1 %
      Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg or kPa or inHg or psi
      Engine speed signal Engine Speed RPM
      Vehicle speed signal Vehicle Speed km/h or MPH
      Ignition timing advance for #1 cylinder Ignition timing adv. #1 °
      Intake air temperature signal Intake Air Temp. °C or °F
      Intake air amount Mass Air Flow g/s
      Throttle position signal Throttle Opening Angle %
      Oxygen sensor #11 Oxygen Sensor #11 -
      Oxygen sensor #12 Oxygen Sensor #12 -
      Rear oxygen sensor output signal Oxygen Sensor #12 V
      Air fuel ratio correction by rear oxygen sensor Short term fuel trim #12 %
      On-board diagnostic system OBD System CARB-OBD2
      A/F sensor output signal A/F sensor #11 V
      A/F lambda signal A/F sensor #11 -
      A/F lambda signal #11 A/F sensor #11 -
      A/F sensor current #11 A/F sensor #11 mA
    NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION  MANUAL.
scientia non olet · About LEMON Manuals