LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Base, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission And Differential >> Main Shaft Assembly >> Installation

Main Shaft Assembly: Installation

  1. Install the needle bearing and oil seal onto the front of transmission main shaft assembly.
    NOTE:
    • Wrap the clutch splined section with vinyl tape to prevent damage to oil seal.
    • Apply grease (Unilube #2 or equivalent) to the sealing lip of oil seal.
    • Use a new one.
  2. Install the needle bearing outer race knock pin hole into transmission case knock pin.
    NOTE: Align the end face of seal with surface (A) when installing oil seal.
    Fig 1: Aligning End Face Of Seal With Surface
    G03751061Courtesy of SUBARU OF AMERICA, INC.
  3. Install the drive pinion assembly. < Ref. to , INSTALLATION , Drive Pinion Shaft Assembly. >
  4. Install the transmission case. < Ref. to , INSTALLATION , Transmission Case. >
  5. Install the transfer case with extension case assembly. < Ref. to , INSTALLATION , Transfer Case and Extension Case Assembly. >
  6. Install the manual transmission assembly to vehicle. < Ref. to , INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals