Steering Wheel: Installation

Align center of roll connector. < Ref. to ADJUSTMENT , Roll Connector . >
Install in the reverse order of removal.

NOTE: Align matching marks on steering wheel and steering column.

Tightening torque:

4.5 N.m (4.5 kgf-m, 32.5 ft-lb)

Column cover-to-steering wheel clearance:

2 - 4 mm (0.08 - 0.16 in)

WARNING: Always refer to "Airbag System" before performing airbag module service (if so equipped). < Ref. to INSPECTION , Driver's Airbag Module . >

CAUTION: Insert roll connector guide pin into guide hole on lower end of surface of steering wheel to prevent damage. Draw out airbag system connector, horn connector and cruise control connectors from guide hole of steering wheel lower end.