LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Base, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Security And Locks >> Keyless Entry System >> Inspection >> Check Ignition Switch Circuit

Check Ignition Switch Circuit

IGNITION SWITCH CIRCUIT

Step Check Yes No
1 CHECK IGNITION SWITCH SIGNAL. 
  1. Disconnect the keyless entry control module harness connector.
  2. Turn the ignition switch to ON.
  3. Measure the voltage between harness connector terminal and chassis ground.

Connector & terminal 
(B176) No. 6 (+) - Chassis ground (-): 		 Is the measured value more than 10 V? Ignition switch circuit is OK. Check the harness for open circuits and shorts between the keyless entry control module and ignition relay.
scientia non olet · About LEMON Manuals