Front Seat: Installation

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE: Tighten the slide rail installing bolt gradually in several steps to the specified torque in the order as shown in Fig 1 .

Fig 1: Tightening Slide Rail

Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Be sure to perform the system calibration for occupant detection system after passenger's seat installation. < Ref. to SYSTEM CALIBRATION , OPERATION, Subaru Select Monitor.> Failure to do so may cause improper activation of passenger's airbag.

Tightening torque:

< Ref. to , COMPONENT , General Description.>